seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Needle bearing on the crankshaft: Pressing out and pressing in > < Crankshaft dimensions

Leon Mk2

Removing and installing drive pinion
Removing and installing drive pinion
t  Removing → Anchor
t  Installing → Anchor
   
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t  counterhold -T20178-, see equivalent → Anchor
t  Thrust piece -U-40002-, see equivalency → Anchor
t  Spanner -U-40090-, see equivalent → Anchor
t  Extractor kit -U-40100B-, see equivalent → Anchor

Removing
–  Remove the valve side sealing flange → Chapter.
–  Remove sump → Chapter.
–  Remove sprocket for oil pump → Item, chain tensioner → Item and chain. → Item
   
–  Remove the crankshaft gear using the support tool -T20178- and theextractor set -U-40100B- with Adapter -U-40100/PP-, use the wrench -U-40090- for the purpose of protecting the crankshaft journal. Due to safety reasons and for the purpose of achieving a compact unit, the Adapter -U-40100/7- shall be fitted as shown in the illustration.
Installing
Continue the installation in the reverse order of removal sequence, observing the following:
  WARNING
Wear protective gloves!
–  Heat the chain sprocket in the oven for about 15 minutes at 220 ºC.
l  Installation location: The wide edge of the sprocket points to the engine.
  E13-10005
–  Fit chain sprocket on crankshaft axle using pliers.
–  Fit chain sprocket on end of crankshaft using pliers and slide with fitting sleeve -U-40002- until fully seated on the crankshaft.
  E13-10009

Needle bearing on the crankshaft: Pressing out and pressing in > < Crankshaft dimensions