seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust pipe front section with particle filter: Removing and installing. > < Exhaust system - Components overview

Leon Mk2

Separating centre and rear silencers
Separating centre and rear silencers
  Note
t  The connecting pipe can be cut through at the point marked in order to renew the centre and rear silencers separately.
t  The cutting point is marked with an indentation on the outside of the exhaust pipe
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Base -U-40075-, see equivalent → Anchor
t  Protective glasses
  W00-2231
Operation process
  WARNING
Wear eye protection.
–  Cut through exhaust pipe at right angles -arrow 2- using pliers -U-40075-.
–  Position the clamp for fitting -4- on the marks -arrow 1- and -arrow 3-.
  A26-0732
–  Install the double clamp, ensuring that the bolt end does not project over the lower edge of the double clamp.
l  Threaded connection faces to rear.
–  Align exhaust system without tension → Chapter
  A26-0159

Exhaust pipe front section with particle filter: Removing and installing. > < Exhaust system - Components overview