| Assembly of hose connections with couplings |
Note | t
| The supercharger air system should not leak |
| t
| The hose connections and the hoses for the charge air system must be free of oil and grease before the assembly. |
| t
| Apply a lubricant for rubbers free from silicone and oil on the leaking surface and on the joint ring. Do not use lubricant products containing silicone or oil. |
| t
| Replace damaged oil seals |
| t
| On replacing the joint ring, place it on the turbocharger hose groove and check that the joint rings cover the entire groove perimeter to prevent damage. |
| t
| Secure all hose connections with the correct hose clips (same as original equipment) → Parts catalogue. |
| t
| For a secure attachment of the charge air pipes to their connections, an anti-corrosive spray must be applied to the bolt thread in used clips before the assembly. |
Caution | The coupling seal may be damaged if the safety fastener is locked when carrying out the assembly. This will cause leaking. Observe the assembly instructions. |
|
|
|
|
