SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Engine and DSG gearbox: Separate >
< Engine: removal, vehicles with front and all-wheel drive (engine code BMN)
Leon Mk2
Power unit
4 cylinder TDI Engine, 2.0 l, 4 V with injector pump, mechanics
Engine assy,cylinder block,crankcase / Engine: removing and fitting
Engine and gearbox: Separate
Engine and gearbox: Separate
Engine and gearbox: Separate
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
counterhold -T20186-, see equivalent
→ Anchor
t
Workshop crane
Operation process
l
Engine/gearbox assembly removed and fixed on engine bracket -T20205-.
–
Unscrew bolt
-1-
with gearbox fitted.
–
Pull the cover plate
-2-
off upwards.
Note
This is shown in the figure with the gearbox removed..
Vehicles with four wheel drive:
–
Extract bolts
-1... 3-
and remove the support for the angular gear.
All vehicles (continued):
–
Unscrew the bolts
-1…8-
on the flange between the engine and the gearbox.
–
Take out starter motor.
Note
The gearbox is shown in illustration with engine removed.
–
Place the support tool -T20186- on the gearbox, as shown in the illustration.
–
Carefully separate the gearbox from the engine, using the workshop crane.
Power unit
4 cylinder TDI Engine, 2.0 l, 4 V with injector pump, mechanics
Engine assy,cylinder block,crankcase / Engine: removing and fitting
Engine and gearbox: Separate
Engine and DSG gearbox: Separate >
< Engine: removal, vehicles with front and all-wheel drive (engine code BMN)