Leon Mk2
Sealing flanges and flywheel - component overview |
1 - | 15 Nm |
2 - | Seal |
q | replace → Chapter |
q | Do not use oil |
3 - | Front sealing flange: |
q | Must sit on dowel sleeves |
q | removing and fitting → Chapter |
4 - | cylinder block |
5 - | Dual-mass flywheel |
q | removing and fitting → Chapter |
q | Fitting is only possible in one position due to the asymmetric holes |
6 - | 60 Nm + 90° (1/4 turn) further |
q | Replace. |
7 - | Intermediate plate |
q | Must sit on dowel sleeves |
q | Do not damage/bend when assembling |
q | Is fitted onto sealing flange → Fig. |
8 - | Sender wheel |
q | For engine speed sender -G28- |
q | Removing and fitting, see rear sealing flange: substitute → Chapter |
9 - | 15 Nm |
10 - | Sealing flange, rear |
q | With seal |
q | replace → Chapter |
11 - | Engine speed sender -G28- |
12 - | 4.5 Nm |
|