seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Exhaust gas recirculation system > < Exhaust gas temperature sender 2, bedplate 1 G448 : removing and fitting

Leon Mk2

Temperature sensor behind particle filterG527: removing and fitting
Temperature sensor behind particle filter -G527-: removing and fitting
t  Removing → Anchor
t  Fitting → Anchor
t  Specified torques → Anchor.
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
   
t  Torque wrench kit -SAT 8010-, see equivalent → Anchor
  L00-10226
t  Articulated wrench e/c 17 -T20212-, see equivalent → Anchor
  L26-10003
Removing
–  Uncouple the electrical connector -2- for the temperature sender after particle filter -G527- and free the electrical wire.
  Note
Disregard - Items 1, 3, 4, 5-.
  A23-10003
–  Unbolt the temperature sender after the particulate filter -G527--1- using the articulated wrench E/C 17 -T20212-.
Fitting
Installation is carried out in the reverse sequence; note the following:
  Note
t  Place threadlock for hot screws on the thread of the temperature sender after particle filter; threadlock for hot screws → Spares catalogue.
t  Fit the cable clamps in the same position as they were.
Specified torques .
  E26-10042
ComponentNm
Temperature sensor after particle filter -G527- to particle filter.45

   

Exhaust gas recirculation system > < Exhaust gas temperature sender 2, bedplate 1 G448 : removing and fitting