Leon Mk2
Note
|
| 1 - | Fuel gauge senders -G- |
| q | Check the resistance → Chapter |
| q | Removing and fitting → Chapter |
| 2 - | Fuel delivery unit with sealing flange |
| q | Fuel pump control unit -G6- check the electric function → Chapter |
| q | Removing and fitting → Chapter |
| q | After fitting, refill a minimum of 5 litres of fuel |
| 3 - | Seal ring |
| q | Replace. |
| q | The part should be dry when mounting it |
| 4 - | Fuel supply line |
| q | Black |
| q | For the fuel filter |
| q | Do not kink |
| q | Goes to connection marked with “V” on flange |
| q | To detach the sealing flange, press the clip to unlock it |
| 5 - | Fuel return line |
| q | Blue colour |
| q | Do not kink |
| q | Goes to connection marked with “R” on flange |
| q | To detach the sealing flange, press the clip to unlock it |
| 6 - | Electrical connector |
| q | For fuel system pressurisation pump -G6- and fuel gauge sender -G- |
| 7 - | Locking ring |
| q | Remove and install with wrench -T10202- . |
| q | Tighten to 110 Nm |
| 8 - | Impulse line |
| q | From the fuel pump to the spray jet |
| q | To disengage, press the clip in the joint to unlock it |
| 9 - | Electrical connector |
| q | For the fuel level sender 2 -G169- |
| 10 - | Locking ring |
| q | Remove and install with wrench -T10202- . |
| q | Tighten to 110 Nm |
| 11 - | Seal ring |
| q | Replace. |
| q | The part should be dry when mounting it |
| 12 - | Fuel gauge sender 2 -G169- |
| q | Will only be delivered with -Pos. 13- |
| q | Check the resistance → Chapter |
| q | removing and fitting |
| q | Installation position → Anchor |
| 13 - | Spray jet: |
| q | Will only be delivered with -Pos. 12- |
| q | Removing and fitting → Chapter |
| q | After fitting, refill a minimum of 5 litres of fuel |
| 14 - | Fuel supply line |
| q | From the spray jet to the fuel supply unit |
| q | Hung on the fuel supply unit |
