–
| Test for open circuits in the wiring between the test box and the double connector, following the wiring diagram. Contact 1+female contact 106 Contact 2+female contact 99 Wire resistance: 1.5 Ω max. |
–
| Also test the wiring for short circuit between wires. Target value: ∞ Ω max. |
If no fault is found in the wiring: |
–
| Loosen the knock sensor and retighten it to a torque of 20 Nm. |
Take the necessary precautions when doing a road test → Chapter. |
During the road test the following operating conditions must be met: |
t
| The coolant temperature must exceed 80 °C |
t
| Once the temperature has been reached, the following load states must be reached several times idling half load full load deceleration |
t
| At full load, revs must exceed 3500 rpm |
–
| Reconsult the fault memory of the control unit. |
–
| Replace the knock sensor -G61- → Item. |
|
|
|