seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Injection pump: removing and fitting > < Rules for cleanliness
Injection pump: repair
Injection pump: repair
Observe rules for cleanliness → Chapter
Removing and fitting the injection pump → Chapter
Check and dynamically adjust the injection commencement valve → Chapter
Always replace the seal and O-rings
   
1 - Actuation element for idle increase
q   Pneumatic for vehicles with air conditioning → Chapter
q   Adjustment
2 - Support
3 - 10 Nm
4 - 20 Nm
5 - Tightening element
6 - Injection pump cogwheel
q   Two piece
7 - 25 Nm
8 - Tightening element
9 - Protection hood
10 - Support
11 - Actuation element for idle increase-N123-
q   Electric for vehicles without air conditioning → Chapter
q   Adjustment
12 - Injection commencement valve-N108-
q   Verification → Chapter
13 - Injection duration sender-G175-, 25 Nm
14 - O-Ring
q   Replacement

   

Injection pump: removing and fitting > < Rules for cleanliness