| –
| Use the tensor lever -U-40050-, secure it with the cotter pin and turn the alternator downward (for example, use the motor pair wrench for the pulling unit of -U-40050-). |
| –
| Remove or install the ribbed trapezoidal belt. |
Note! | When the ribbed trapezoidal belt is assembled, it must be well-adjusted in the transmission pulleys. |
| –
| After installing the ribbed trapezoidal belt with the alternator loose, start up the engine several times (approx. 10 rpm), activating the throttle for a short time. |
| –
| First tighten the lower, then the upper, alternator bolts 25 Nm. |
|
|
|
