Leon Mk2
Note!
|
| 1 - | 0.3...0.7 bar oil pressure switch -F1-, 25 Nm |
| q | Checking → Chapter |
| q | If sealing ring is leaking nip open and replace seal |
| 2 - | 10 Nm |
| 3 - | Oil deflector |
| 4 - | To air filter |
| 5 - | Sealing cap |
| q | Renew seal if damaged |
| 6 - | Dipstick |
| q | The oil level must not be above the max. mark! |
| q | Markings → Fig. |
| 7 - | Funnel |
| q | Pull off to extract oil |
| 8 - | Guide tube |
| 9 - | Main drive toothed belt |
| q | Mark direction of rotation before removing |
| q | Check for wear |
| q | Do not kink |
| q | Toothed belt routing → Fig. |
| q | Removing, installing and tensioning → Chapter |
| 10 - | Main drive toothed belt idler roller |
| 11 - | Oil filter |
| q | Loosen at hexagon bolt head |
| q | Screw in union by hand as far as it will go |
| q | Tighten filter by hand |
| q | Note instructions printed on filter when installing |
| 12 - | Oil pump |
| q | Only renew complete |
| q | When installing note follower on crankshaft → Item |
| q | Must be located on dowel sleeves |
| q | Removing and installing → Chapter |
| 13 - | 12 Nm |
| q | Renew |
| 14 - | Toothed belt guard - upper part |
| 15 - | Toothed belt guard - lower part |
| 16 - | Tighten to 90 Nm + continue tightening 1/4 turn (90°) |
| q | Renew |
| q | Oil threads |
| q | Tightening can be done in several stages |
| q | The tightening angle can be measured using protractor -T20030- |
| 17 - | Pulley |
| q | When installing note fixing arrangement |
| q | Removal and installation → Chapter; Toothed belt: Removing, installing and tensioning |
| q | Removing and installing ribbed belt → Chapter |
| 18 - | Crankshaft toothed belt- sprocket |
| q | Note position when installing toothed belt → Chapter |
| 19 - | Sealing ring |
| q | Renew → Chapter |
| 20 - | Gasket |
| q | Renew |
| q | Must be located on dowel sleeves |
| 21 - | Gasket |
| q | Renew |
| 22 - | Suction pipe |
| q | Clean filter if soiled |
| 23 - | 20 Nm |
| 24 - | Main drive tensioning roller |
| q | Checking → Chapter |
| q | Tensioning toothed belt → Chapter |
| 25 - | Sump |
| q | Removal and installation → Chapter |
| q | Clean sealing surface before installing |
| q | Insert with silicone-based sealant -D 176 404 A2- |
| 26 - | Oil drain screw, 30 Nm |
| q | With attached seal |
| q | Renew |
| 27 - | Cable guides |
| 28 - | 15 Nm |
| q | Only tighten or loosen bolts situated on the same side as flywheel using fitting tool -U-40051- |
| 29 - | Follower |
| q | Coat with oil before installing oil pump |
| 30 - | O-ring |
| q | Renew |
