Leon Mk2
| Exhaust manifold, front exhaust pipe with catalytic converter attachments (engine codes AFK) |
| 1 - | Warm air collector plate |
| 2 - | 10 Nm |
| q | Note tightening sequence → Fig. |
| 3 - | Exhaust manifold |
| 4 - | Gasket |
| q | Renew |
| q | Note fitting position |
| 5 - | 25 Nm |
| q | Renew |
| 6 - | Marking |
| q | Three times on circumference |
| q | S = Manual gearbox A = Auto. gearbox |
| 7 - | To front silencer |
| 8 - | Heat shield |
| 9 - | 10 Nm |
| 10 - | Front exhaust pipe with catalytic converter |
| 11 - | Lambda probe -G39-*, 50 Nm |
| q | Only grease threads with -G 052 112 A3-. -G 052 112 A3- must not get into the slots on the probe body |
| q | If sealing ring is leaking nip open and replace seal. |
| q | Checking Lambda probe regulation: → Chapter |
| q | Remove and install with open ring spanner -U-40080- |
| 12 - | 40 Nm |
| q | Renew |
| 13 - | Gasket |
| q | Renew |
| 14 - | Support |
|
|
