seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Checking activation > < Test sequence

Leon Mk2

Checking voltage supply
Checking voltage supply
   
–  Using multimeter and adapter cables from -V.A.G 1594- measure the supply voltage between contacts 2+4 of disconnected connector.
–  Switch on ignition. Specification: min. 11.5 V
–  Switch off ignition.
If no voltage is present:
  N28-0133
–  Check wire between 4-pin connector contact 2 and relay plate for open circuit according to current flow diagram. Wire resistance: max. 1.5 Ω
–  Check wire between 4-pin connector contact 4 and earth for open circuit according to current flow diagram. Wire resistance: max. 1.5 Ω
  A24-0094

Checking activation > < Test sequence