Leon Mk2
| Fitting locations overview |
| 1 - | 4-pin connector |
| q | For lambda probe |
| q | On the engine bracket, to the right hand side |
| 2 - | Connector |
| q | For the injector and for the inlet air temperature sender |
| 3 - | Fuel pressure regulator |
| 4 - | Injector -N30- with inlet air temperature sender -G42- |
| 5 - | Throttle actuator -V60- with idle switch |
| 6 - | Throttle potentiometer -G69- |
| 7 - | Temperature regulator |
| q | For the inlet air pre-heating |
| 8 - | Injection unit |
| 9 - | Inlet manifold pre-heater connector |
| 10 - | Ignition coil -N152- |
| q | With final stage for ignition coil -N157- → Item |
| 11 - | Relay for intake manifold pre-heating -J81- |
| q | Location: on the relay carrier plate found in the footrest area, on the driver side |
| 12 - | Monomotronic injection and ignition system control unit -J257- |
| 13 - | Ignition distributor with Hall transmitter -G40- |
| q | → Item |
| 14 - | Coolant temperature sender -G62- |
| q | With coolant temperature gauge sender -G2- |
| 15 - | Earth connection |
| 16 - | Depression capsule |
| q | For the inlet air pre-heating |
| 17 - | Solenoid valve 1 for the active carbon filter -N80- |
| q | → Rep. Gr.20 |
| 18 - | Air filter |
