seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Vehicle inclination senderG384 > < Anti-theft alarm sensorG578

Leon Mk2

Removing and installing anti-theft alarm sensorG578
Removing and installing anti-theft alarm sensor -G578-
Special tools and workshop equipment required
   
t  Removal wedge -3409-
  Note
t  When removing and installing components that are in view (switches, covers, trim and so on), mask off areas in which tools (removal wedge -3409-, screwdriver) are used to lever out those components using commercially available tape.
t  The following illustrations show removal and installation of the anti-theft alarm sensor -G578- on a vehicle with sliding/tilting sunroof. Removal and installation of anti-theft alarm sensor -G578- on vehicles without sliding/tilting sunroof are carried out in the same way.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove front interior light → Chapter
  W00-0016
–  Release the three locking lugs -arrows- and remove anti-theft alarm sensor -G578--1- from interior light, taking connected wiring length into consideration.
  N96-10897
–  Unclip wires from brackets -1-.
–  Release fasteners -arrows- and pull out both receivers -2- and interior monitoring sender -3- from interior light.
–  Take anti-theft alarm sensor -G578- out of vehicle.
Installing:
For fitting, the operations are carried out in reverse order to the removal, taking the following into account:
  Note
t  To prevent malfunction of the anti-theft alarm sensor, both sensors and the interior monitor receiver must be installed in their correct location in the interior light.
t  The sensors which are wired to the control unit as a pair, are the senders and these must be engaged into the outer mountings of the interior light.
t  The single sensor is the receiver, and it must be installed into the middle mounting of the interior light.
  N96-10896

Vehicle inclination senderG384 > < Anti-theft alarm sensorG578