seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing bulb holder > < Assembly overview: Rear lights on bodywork

Leon Mk2

Rear lights on the bodywork: Removing and installing
Rear lights on the bodywork: Removing and installing
Removal:
–  Switch off ignition and all electrical consumers and take out ignition key.
–  Turn light switch to „0“ position.
   
–  Lift the shaped area of the luggage compartment trim.
–  Remove threaded stud -1-.
  E94-10269
–  Swing the tail gate -2 - outwards -arrow-.
–  Unplug connector -arrow-.
Installation
l  Tightening torque → Chapter
  E94-10268
Installation is carried out in reverse order, noting the following:
  E94-10268
–  The tail light on the body and subsequently retaining pins-1-on the body to use pressure.
–  Tighten threaded stud -1-.
  E94-10269

Removing and installing bulb holder > < Assembly overview: Rear lights on bodywork