seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Verification of lamp alignment (with new screen without line of order of 15?) > < Bulbs for fog lamps: removal and installation

Leon Mk2

Lamp operations: verify, and if necessary, adjust
Lamp operations: verify, and if necessary, adjust
Special tools and workshop equipment required
   
t  Regulator for lamp -SAT 1300-
In principle, the following conditions for adjustment and verification are admisible for all foreign markets. But legal guidelines and prescriptions of each country should be followed
Check conditions
t  Correct tyre pressure
t  The reflector crystals should not be damaged or dirty
t  Correct reflectors and lamps
t  Check the vehicle load
Load: With one person or 75 kg on top of the driver's seat and no other kind of weight (empty weight)
The empty weight is the weight of the vehicle in service conditions with the fuel tank completely full (90% at a minimum), including the weight of all the additional equipment necessary for servicing (i.e. spare tyre, tools, jack, fire extinguisher, etc.)
The vehicle should have travelled some meters, or better push the vehicle downwards several times from the front and the rear, to make sure the springs are correctly adjusted
t  The vehicle and the lamp regulators should be over a flat surface. The distance between the lamp alignment unit and the lamp should be 30 cm → Instruction manual for the lamp alignment unit
t  The vehicle and the lamp alignment unit should be in line
t  The height of inclination should be adjusted
  W00-2713
Over the embellisher in the upper zone of the lamp are engraved -A-, the height of inclination in “%”. The lamps should be adjusted according to these figures. The percentage figures on the sticker refer to a distance of projection of 10 m. the height of inclination, for example.
1 - .2 % represents 12 cm
t  The lamp reach regulator potentiometer, located in the instrument panel, should, be in position -0-
  E94-0141

Verification of lamp alignment (with new screen without line of order of 15?) > < Bulbs for fog lamps: removal and installation