seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Tailgate bulb holder: Removing and installing > < Rear lights on the bodywork and tailgate: Exeo ST

Leon Mk2

Lamp holder on the bodywork: Removing and installing
Lamp holder on the bodywork: Removing and installing
Removal:
–  Switch off ignition and all electrical consumers and take out ignition key.
–  Turn light switch to „0“ position.
   
–  Rear lights on the bodywork: Removing → Chapter.
–  Press the lacings -arrow-.
–  Take bulb holder -2- out of tail light -1-.
  Caution
Do not apply excessive force to the bulb holder in order not to force the wires of the LED module.
  E94-10359
The plug connector of the LED module is similar to the lamp holder.
–  Unscrew the bulb -1- for the indicator from the bulb holder -4-.
–  Separate the plug connector of the LED module -3- from the lamp holder -4-.
Installation
l  Tightening torque → Item
Installation is carried out in reverse order, noting the following:
–  Fit new bulbs in bulb holder; do not touch the glass part of the bulb with bare hands.
–  Switch the plug connector of the LED module.
–  Route the wiring harness of the LED module to its fitting position without interruptions.
  E94-10360

Tailgate bulb holder: Removing and installing > < Rear lights on the bodywork and tailgate: Exeo ST