seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Lamp holder, movable lighting system: removing and installing > < Lamp holder, fixed lighting system: removing and installing

Leon Mk2

Tail light on the tail gate: removing and installing
Tail light on the tail gate: removing and installing
Special tools and workshop equipment required
   
t  Lever -U 30800-
  W00-2169
t  torque wrench set -SAT 8010-
Removing
–  Switch off ignition and all electrical consumers and remove ignition key.
  L00-10226
–  Turn light switch to position „0“.
  E94-10339
–  Remove interior trim -1- using the lever -U30800-.
–  Remove the connector -1-.
  E94-10340
–  Unscrew nut -2-.
–  Swing the tail lights -1- slightly from the tailgate -arrow A- and in the direction of -arrow B-.
Installing
Installation is carried out in reverse order, noting the following:
l  Tightening torque → Chapter.
  Note
Ensure that gasket between body and tail light housing seals completely.
  E94-10341

Lamp holder, movable lighting system: removing and installing > < Lamp holder, fixed lighting system: removing and installing