seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Coding reversing camera system control unitJ772 > < Reversing cameraR189: Removing and installing

Leon Mk2

Removing and installing reversing camera system control unitJ772
Removing and installing reversing camera system control unit -J772-
Control unit is installed in luggage compartment behind left side panel trim.
Removing:
–  Switch off ignition and all electrical loads, and pull out ignition key.
   
–  Remove the cover of the storage compartment -3- on the left side part of the luggage compartment.
–  Remove bolts -2-.
–  Remove the storage compartment -1- on the left side part of the luggage compartment.
  E94-10437
For greater clarity, the left side part of the luggage compartment is not shown in the illustration.
–  Push retainers -arrows- outwards and swing out control unit for reversing camera system -J772--2- from bracket.
–  Release connector T54b -1- and disconnect.
–  Release connector 2b of the video signal via connector T54b -1- and disconnect.
Installing:
Installation is carried out in reverse order.
Only if control unit has been renewed:
–  Coding control unit → Chapter.
–  Recalibrating reversing camera system → Chapter.
  N94-12115

Coding reversing camera system control unitJ772 > < Reversing cameraR189: Removing and installing