seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Rear lights > < Entry light in exterior mirror

Leon Mk2

Removing and installing drive side entry light in exterior mirrorW52
Removing and installing drive side entry light in exterior mirror -W52-
The driver side entry light in exterior mirror -W52- and the front passenger side entry light in exterior mirror -W53- are installed in the lower part of respective left or right exterior mirror housing. Renewal of entry light bulb is described below.
  Note
t  In the event of damage to the lens, entry light in exterior mirror must be renewed together with lower part of exterior mirror housing.
t  The procedure for renewal of the bulb on the driver and front passenger side is the same and is therefore described for one side only.
Renewing bulb:
–  Switch off ignition and all electrical loads, and pull out ignition key.
–  Remove the bottom part of the housing → Bodywork, exterior fitting work; Rep. gr.66.
   
–  To release, twist holder -1- in -direction of arrow- and pull out together with bulb.
  N94-11285
–  Pull out wedge-base bulb -1- in -direction of arrow- straight from bulb holder -2-.
Glass base bulb: 12 V, 5 W
Installing:
Installation is carried out in the reverse sequence; note the following:
  Note
After installing, check operation of exterior mirrors.
  N94-10329

Rear lights > < Entry light in exterior mirror