seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Vehicles with 1.8 litre turbo engine (110 kW), manual gearbox > < Vehicles with 1.4l fuel injection engine (51, 55 and 74 kW), manual gearbox

Leon Mk2

Vehicles with 1.4 litre fuel injection engine (59 kW), manual gearbox
Vehicles with 1.4 litre fuel injection engine (59 kW), manual gearbox
Special tools and workshop equipment required
   
t  Torque wrenches -SAT 8010-
Removing:
–  Disconnect battery → Chapter.
–  Removing the sound insulation → Body, exterior fitting work; Rep. Gr.50.
  L00-10226
–  Unscrew the nut -1- of the lower bolt on the starter motor -2-.
–  Remove support -3-.
–  Remove bolt -2- securing the lower part of the starter motor.
–  Remove the battery support → Chapter
  N27-10212
–  Release and detach the connection -1- on terminal 50.
–  Remove star head screw -2-.
  N27-10558
–  Unscrew the securing nut -1- and remove the cable -2- from the magnetic switch of terminal 30.
–  Unscrew the nut -3- of the upper bolt on the starter motor.
–  Remove the earth cable -4- and the upper securing bolt of the rear starter motor.
–  Remove the starter motor pulling upwards.
Fitting:
Installation is carried out in the reverse sequence; note the following:
–  Tighten the fastening bolts or nuts to the torques shown → Chapter .
–  Connect battery → Chapter.
  N27-10559

Vehicles with 1.8 litre turbo engine (110 kW), manual gearbox > < Vehicles with 1.4l fuel injection engine (51, 55 and 74 kW), manual gearbox