seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Vehicles with 2.0 litre TDI engine and 4V 105/125 kW > < Vehicles with 1.6 and 1.8 litre turbo engine

Leon Mk2

2.0l TSI 147 kW vehicles, manual gearbox 01XE
2.0l TSI 147 kW vehicles, manual gearbox 01XE
Removal:
–  With the ignition switched off, disconnect battery earth cable → Chapter.
   
–  Loosen the screws or quick-type locks -1 - and - 2- and remove front noise insulation.
  A10-1320
–  Unscrew the screws -1- for right drive shaft heat shield.
  A10-0961
–  Unscrew bolts -1- and -2-.
  A27-0028
–  Take the starter motor upwards and swivel to the side.
–  Unplug the electrical connector -3-.
–  Unscrew the nut -1- for the clamp.
–  Unscrew the nut -2- and remove the electric cables.
–  Unscrew the bracket for the starter from the cylinder block and from starter.
–  Remove starter motor.
Installation
Installation is carried out in reverse order, noting the following:
–  Connect battery. Steps required → Anchor.
Tightening torques
  A27-10038
Components:Nm
Starter motor to gearbox65
Terminal B+ to starter16

   

Vehicles with 2.0 litre TDI engine and 4V 105/125 kW > < Vehicles with 1.6 and 1.8 litre turbo engine