seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Windscreen wiper brushes: adjusting the end position > < Removing the windscreen wiper frame motor

Leon Mk2

Installing the windscreen wiper motor in the windscreen wiper chassis
Installing the windscreen wiper motor in the windscreen wiper chassis
–  Allow the windscreen wiper motor to run at the end position: To do so, attach the connector to the windscreen wiper motor and briefly operate the switch for the windscreen wipers.
–  Disconnect anew the connector and secure the windscreen wiper motor with M6 screws.
Tightening torque: 8 Nm.
   
–  Fit the window regulator so that the rods are in line, as shown in the illustration.
–  Tighten the M8 hexagonal bolt -2- (tightening torque: 20 Nm).
–  press the dipsticks -1- against the crank again.
  E92-0019

Windscreen wiper brushes: adjusting the end position > < Removing the windscreen wiper frame motor