| Indications on the repair of support wiring and connectors |
| Complementary information on the repair of CAN bus cables → Chapter. |
| t
| Soldering cannot be used when repairing the onboard power supply |
| t
| As a rule, weld joints should not be repaired. If there is a faulty cable, a new cable must be laid parallel to the faulty one |
| t
| Only use yellow cables when repairing the support wiring. Mark the points where repairs have been made with yellow adhesive tape |
| t
| Screened wires should not be repaired. If they are damaged then they must be replaced completely |
|
|
|
