seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Comfort system central control unitJ393: removing and fitting > < 4-position relay carrier: Removing and installing

Leon Mk2

Removing and installing connector point (left-side)
Removing and installing connector point (left-side)
Removal:
   
–  Switch off ignition and all electrical consumers and take out ignition key.
t  Installation location: the connector point (left-side) -arrow- is located in footwell (left-side) beneath A-pillar trim.
–  Switch off ignition and take out ignition key.
–  Remove A-pillar trim → Rep. gr.70.
–  Press retaining clip and detach connector point from A-pillar -arrow-.
–  Unclip fuse holder from connector point.
–  Withdraw relays or control units and then unclip appropriate relay carrier.
  Note
Exact assignment of connector point can be found in appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installation
Installation is carried out in reverse order, noting the following:
–  Install A-pillar trim → Rep. gr.70.
  A97-0270

Comfort system central control unitJ393: removing and fitting > < 4-position relay carrier: Removing and installing