seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Main fuse holder: Removing and installing > < 4-position relay carrier in plenum chamber electronics box: Removing and installing

Leon Mk2

Removing and installing connector point in electronics box (plenum chamber)
Removing and installing connector point in electronics box (plenum chamber)
Removal:
–  Disconnect battery . → Chapter
–  Remove storage compartment (driver side) → Rep. gr.68.
–  Unscrew electrical wire at bottom of connector point in plenum chamber electronics box.
–  Remove plenum chamber cover -1- to front.
   
–  Remove both wiper arms -2--item 3 and 4- → Chapter.
  Caution
To stop the cowl panel grille -5- being torn on removal, apply a small quantity of soap solution to the transition between the windscreen and cowl panel grille and pull the cowl panel grille vertically upwards out of the fastening strip, starting at the edge of the windscreen.
–  Pull off retaining clips -1- and remove the cowl panel grille -5-.
  E92-10097
–  Remove cover for electronics box in plenum chamber -arrows-.
  A10-0996
–  Use screwdriver to pry off retaining strap -arrows-.
–  Lay aside engine control unit with wires attached.
–  Release retaining clip for gearbox control unit.
–  Lay aside gearbox control unit with wires attached.
–  Unplug electrical connectors at rear of connector console.
  Note
  A10-0997
Exact assignment of connector point in electronics box (plenum chamber) can be found in appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
–  Unscrew electrical wire -3-.
–  Unscrew bolts -2- and -4-.
–  Unclip appropriate socket -1-.
  Note
Exact assignment of connector point in electronics box (plenum chamber) can be found in appropriate current flow diagram → Current flow diagrams, Electrical fault finding and Fitting locations.
Installation
Installation is carried out in reverse order, noting the following:
–  Connect battery. Fault rectification:
t  Battery in engine compartment → Anchor
Tightening torques
  A97-10098
Components:Nm
Connector point in plenum chamber electronics box to central tube for dash panel3
Screw connection for electrical wires9

   

Main fuse holder: Removing and installing > < 4-position relay carrier in plenum chamber electronics box: Removing and installing