seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clamping sleeve: Removing and installing. > < Removing and installing electric socket or cigarette lighter

Leon Mk2

Removing and installing spring pin and cigarette lighter illumination bulbL28
Removing and installing spring pin and cigarette lighter illumination bulb -L28-
  Note
t  On some vehicles, the illumination is not provided by a light bulb, but by an LED (light-emitting diode), depending on the equipment level. This LED is permanently attached to the retaining sleeve and cannot be renewed separately.
t  Retaining sleeves with a light bulb are available in different versions. One version where the light bulb can be replaced individually and one where the individual light bulb change is not possible. In this case, the bulb carrier has to be replaced together with the light bulb.
Removing:
   
–  Removing the electric socket → Chapter.
–  Press the retaining tabs together -arrows-.
–  Remove the clamping sleeve with light bulb holder.
  N96-10628
–  Press in the clamping sleeves -arrows- and help along using a screwdriver with flat end.
–  Clip out the light bulb carrier -2- from the clamping sleeve -1-.
  E96-10156
–  Remove the light bulb carrier -2- from its bracket -3-.
–  The retaining tags -1- and -2- slacken.
  E96-10157
–  Open the light bulb holder.
–  Pull out the light bulb -1- in the -direction of the arrow-.
Installing:
Installation is carried out in reverse order.
  N96-10630

Clamping sleeve: Removing and installing. > < Removing and installing electric socket or cigarette lighter