| t
| Battery charger -VAS 5095 A- |
Caution | During the charge operation the battery type must always be selected 2.4 V/Z (volts / battery cell). This applies for all batteries. |
|
Note | The battery must have a temperature of at least 10 °C. |
WARNING | The batteries whose magic eye a clear yellow or clear colour should not be tested nor charged. Do not perform an auxillary start. |
| The risk of explosion exists upon testing and charging or performing an auxillary start. |
| These batteries must be renewed. |
|
| –
| Turn off the ignition and all electricity consumers. |
| –
| Check the battery type selection on the battery types switch → Chapter. The switch must be set to 2.4 V/Z (volts / battery cell). |
| –
| Connect the red charge clamp „+“ of the charger to the positive pole of the battery. |
Note | On vehicles with Start / Stop function and battery monitor control unit -J367-, the black charging terminal „-“ must be connected to the body earthing. Connecting it to battery negative terminal will cause start/stop system to malfunction. |
| –
| Connect the black charge terminal „-“ of the charger to the negative pole of the battery. |
| The charge current indicators → Fig.-2- and -3- light up yellow. If only one LED lights -3-, this means that the battery is partially charged (approx. |
| If the green LED → Fig.-4- is lit this means that the charger has switched to charge maintenance. The battery is charged. |
| –
| Remove the charge clamps from the terminals on the battery poles. |
|
|
|
