SEAT Workshop Service and Repair Manuals > Leon Mk2 > Vehicle electrics | Vehicle electrics | Wiring | Relay carrier, fuse holder, E-boxes | Removing and installing relay and fuse holder behind dash panel on driver side | Removing and installing fuse holder behind dash panel on driver side

Removing and installing fuse holder behind dash panel on driver side

The fuse holder is located behind the right-hand side of the dash panel cover.

Special tools and workshop equipment required

t	Torque wrench -V.A.G 1410-

Caution

To disconnect and reconnect the battery, the procedure described in the workshop manual should be strictly adhered to → Chapter.

Note

t	The illustrations show removal and installation of the fuse carrier in an LHD vehicle.

t	Removal and installation of the fuse carrier in an RHD vehicle are analogous.

Removing:

–	Switch off ignition and all electrical consumers, and remove ignition key.

–	Disconnect battery . → Chapter

–	Insert removal wedge -VAS 3409- or a screwdriver into opening -2- and lever the -1- dash panel cover off in -direction of arrow-.

–	Undo and remove screw -arrow- and pull fuse holder -1- together with carrier -2- upwards off the body.

Installing:

Install in the same way but in reverse order of removal. When doing this, note the following:

–	Tighten screw to specified torque of 1.5 Nm.