Fabia Mk1
Summary of components |
– | Testing compression pressure → Chapter. |
Note
t | Removing and installing intake manifold: → Chapter. |
t | Removing and installing exhaust manifold → Chapter. |
t | If the cylinder head is replaced, the system must be completely filled with fresh coolant. |
1 - | 3 Nm |
2 - | Sealing ring |
q | replace |
3 - | Cylinder head bolt |
q | moisten with oil before screwing in |
q | tightening order and tightening torque → Chapter |
4 - | Washer |
5 - | Lifting eye - on the left |
6 - | Rocker arm shaft |
q | Remove and install rocker arm shaft → Chapter |
q | Basic setting of the hydraulic valve clearance compensation → Chapter |
7 - | Support |
q | for ignition terminal |
8 - | Shim |
9 - | 23 Nm |
q | do not tighten fully until cylinder head bolts have been tightened |
10 - | 20 Nm |
q | self-locking, replace |
q | do not tighten fully until cylinder head bolts have been tightened |
11 - | 20 Nm |
q | coat with -AMV 105 500- (Loctite 242) before screwing in |
q | do not tighten fully until cylinder head bolts have been tightened |
12 - | Support |
q | for generator support |
13 - | Cylinder head gasket |
q | observe correct installation position; with the marking of the part number to the top |
q | replace |
14 - | Cylinder head |
q | check for distortion → Fig. |
q | removing and installing → Chapter |
q | after replacing fill entire system with fresh coolant |
15 - | Oil deflector |
16 - | 25 Nm |
17 - | Lifting eye - on the right |
18 - | Gasket for cylinder head cover |
q | replace if damaged |
19 - | Cylinder head cover |
20 - | Screw cap |
q | fit on during installation work |