Fabia Mk1
Removing and installing parts of the injection system |
1 - | Engine control unit -J361- |
q | Fitting location: bulkhead plenum chamber |
q | clipped into holder |
q | replace → Chapter |
2 - | 40-pin plug |
q | Insert or remove plug when the ignition is switched off |
q | unlock to remove |
3 - | 81-pin plug |
q | Insert or remove plug when the ignition is switched off |
q | unlock to remove |
4 - | Air filter |
q | Summary of components → Chapter |
q | removing and installing → Chapter |
5 - | Inlet connection with control flap |
6 - | Hot-air intake hose |
7 - | Screw clamp, 2 Nm |
8 - | Connector |
q | for coolant temperature sender -G62- |
9 - | Coolant temperature sender -G62- |
q | before removing, adjust the pressure in the cooling system if necessary |
10 - | Lambda probe -G39-, 50 Nm |
q | Fitting location: in pre-exhaust pipe upstream of catalytic converter |
q | the thread of new lambda probes must be coated with assembly paste |
q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
q | use lambda probe wrench for removing and installing |
11 - | Connector |
q | for lambda probe and lambda probe heating before catalyst |
q | 4-pin: on engines with identification characters ARV, AME, AZE |
q | 6-pin: on engines with identification characters AQV, ATZ, AQW, AZF |
12 - | 4-pin plug |
q | for lambda probe and lambda probe heater downstream of catalytic converter (only on engines with identification characters AQV, ATZ, AQW, AZF) |
13 - | Lambda probe -G130-, 50 Nm |
(only engines with identification characters AQV, ATZ, AQW, AZF) |
q | Fitting location: in exhaust pipe downstream of catalytic converter |
q | the thread of new lambda probes must be coated with assembly paste |
q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
q | use lambda probe wrench for removing and installing |
14 - | Intake manifold |
q | Summary of components → Chapter |
15 - | Fuel intake hose |
q | white marking |
q | secure on fuel rail with spring strap clamps |
16 - | of the crankcase ventilation |
17 - | Inlet connection |
q | via the throttle valve control unit |
18 - | 8 Nm |
19 - | Air intake hose |
20 - | Spring strap clamp |
q | disassemble and assemble with pliers for spring strap clamps |
|