Fabia Mk1
Summary of components |
1 - | Defroster vent |
q | integrated in dash panel |
2 - | Centre dash panel vent |
q | with warning light switch |
q | removing and installing → Fig. |
3 - | Dash panel |
q | Removing and installing → Body Work; Rep. Gr.70 |
4 - | Side window vent |
q | use plastic edge -3409- to carefully lever out |
5 - | Outer dash panel vent |
q | use plastic edge -3409- to carefully lever out at top and bottom (in the same way as for the centre dash panel vent) |
6 - | Intermediate piece for dash panel vents |
q | attached to heater unit with clips |
q | for removing, take out dash panel |
7 - | Centre part of dash panel |
q | Removing and installing → Body Work; Rep. Gr.70 |
8 - | Module carrier |
9 - | Heater unit |
q | Summary of components → Chapter |
q | disassembling and assembling → Chapter |
q | removing and installing → Chapter |
10 - | Right footwell vent |
q | bolted to heater unit (1.5 Nm) |
11 - | Connection part for rear duct |
12 - | Rear duct |
13 - | End piece for rear duct |
q | clipped into rear duct and seat cross member |
14 - | Ventilation frames |
q | clipped into rear cross member ahead of spare wheel well from outside |
q | sealing lips must operate freely and close automatically |
q | Area in front of ventilation frames must be clear otherwise ventilation of interior does not operate |
15 - | Left footwell vent |
q | bolted to support (1.5 Nm) |
16 - | Gasket |
q | for connection of heat exchanger |
q | in bulkhead (assembly plate) |
17 - | Intermediate piece for defroster duct |
q | fitted onto heater unit and module carrier |
q | for removing, take out dash panel |