skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing series resistor for fresh air blowerN24 > < Removing and installing parts of the heater unit - Part 1

Fabia Mk2

Removing and installing fresh air blowerV2
Removing and installing fresh air blower -V2-
Removing
–  Removing the dash panel → Body Work; Rep. gr.70.
–  If affixed, take off the noise insulation from the blower.
   
–  Unplug connector -2-.
–  Release cable from the clips -1- and -3-.
–  Separate connector -4- and unplug from the fresh air blower cover -5-.
   To do so push the right plug forwards while simultaneously pushing outwards.
–  Unbolt screws -arrows- (1 Nm) and take fresh air blower -5- out of the housing.
  S80-0102
–  Using a narrow screwdriver press the catch pegs -2- of the plug connection housing outwards in the direction of the arrow and press plug connection -1- downwards out of the catch.
–  Press catches -3- inwards and down with a screwdriver.
–  Remove fan motor and fan wheel from holder.
Install
Installation is carried out in the reverse order. Pay attention to the following:
t  Fresh air blower motor: pay attention to different versions → Electronic Catalogue of Original Parts.
t  The plug connection must lock securely in the housing.
t  The rubber elements of the engine holder -3- must fully protrude from the housing.
t  Before installing check the operation of the fresh air blower.
  S80-0104

Removing and installing series resistor for fresh air blowerN24 > < Removing and installing parts of the heater unit - Part 1