Fabia Mk2
| Disassembling and assembling the heater unit |
Note| Connection elements of the heater unit → Fig. |
| 1 - | Heater unit wiring loom |
| q | carefully cut open to remove cable strap |
| q | when installing new cable strap fit in same location |
| 2 - | Housing top and bottom part |
| q | Connection with retaining clips |
| 3 - | Fresh air blower series resistor -N24- |
| q | with overheating fuse |
| q | removing and installing → Chapter |
| 4 - | Housing for air inlet |
| q | with fresh and re-circulating air flap |
| q | Fitted to housing top and bottom part with retaining clips |
| 5 - | Gasket |
| q | replace if damaged |
| q | self-adhesive |
| q | before fitting remove glue residues on housing for air inlet with acetone |
| 6 - | Fresh air flap and re-circulating air flap control motor -V154- |
| q | removing and installing → Chapter |
| 7 - | Support |
| q | for fresh air flap and re-circulating air flap control motor -V154- |
| 8 - | Fresh air blower -V2- |
| q | removing and installing → Chapter |
| 9 - | Holder for fresh air blower -V2- |
| 10 - | Filter cover |
| 11 - | Dust and pollen filter |
| q | also as combination filter with odour filter see → Electronic Catalogue of Original Parts |
| q | removing and installing → Chapter |
| 12 - | Positioning unit for air distribution flaps |
| q | removing and installing → Chapter |
| 13 - | Bottom part of distributor housing |
| 14 - | Heating element for air auxiliary heating -Z35- |
| q | removing and installing → Chapter |
| 15 - | Heat exchanger |
| q | removing and installing → Chapter |
| 16 - | Top part of distributor housing |
| q | Connection with air distributor housing, bottom part with retaining clips |
| 17 - | Support, left |
| q | forms an inseparable component with the central pipe, screwed to heater unit and centre console support |
| q | Tightening torque of the heater unit: 5 Nm |
| q | Centre console support tightening torque: 10 Nm |
| 18 - | Control motor for temperature flap |
| q | removing and installing → Chapter |
