Fabia Mk2
| Pre-exhaust pipe with diesel particle filter for vehicles according to EU 5 standard (left-hand drive) - Summary of components |
Note| t | If the particle filter or the differential pressure sender -G505- is replaced, the differential pressure sender -G505- must be adapted → Vehicle diagnostic tester; adapt „Targeted functions“; Differential pressure sender -G505-. |
| t | The exhaust turbocharger and the exhaust manifold are one component part; remove and install → Chapter. |
| t | Double clamp between pre-exhaust pipe and rear part of exhaust system → Chapter. |
| 1 - | Differential pressure sender -G505- |
Caution
|
| q | removing and installing → Chapter |
| 2 - | 3 Nm |
| 3 - | Control line |
| 4 - | Spring strap clamp |
| 5 - | Exhaust gas temperature sender 4 -G648-, 45 Nm |
| q | the thread of the new temperature sender must be coated with assembly paste |
| q | coat only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender |
| q | for removing and installing, use wrench T10395/6 |
| q | installing → Chapter |
| 6 - | Lambda probe -G39-, 50 Nm |
| q | the thread of new lambda probes must be coated with assembly paste |
| q | for a re-used lambda probe, only coat the thread with hot bolt paste -G 052 112 A3- |
| q | the hot bolt paste -G 052 112 A3- must not come into contact with the slots of the probe body |
| 7 - | Heat shield |
| 8 - | 9 Nm |
| 9 - | Pre-exhaust pipe |
| q | with oxidation catalytic converter and diesel particle filter |
| q | removing and installing → Chapter |
| 10 - | Gasket |
| q | replace |
| q | Check fitting position |
| 11 - | Warm-type clamp, 7 Nm |
| q | replace |
| 12 - | 23 Nm |
| 13 - | 23 Nm |
| 14 - | Support |
| q | bolted to engine support |
| 15 - | Exhaust gas temperature sender 3 -G495-, 45 Nm |
| q | the thread of the new temperature sender must be coated with assembly paste |
| q | coat only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender |
| q | for removing and installing, use wrench T10395/6 |
| q | installing → Chapter |
| 16 - | Support |
| 17 - | 23 Nm |
| 18 - | Support |
| q | for differential pressure sender -G505- |
