Fabia Mk2
|
1 - | Exhaust gas pressure sensor 1 -G450- |
2 - | Support |
3 - | Nut |
4 - | Lambda probe -G39- - 50 Nm |
q | only coat the thread with hot screw paste -G 052 112 A3-; the paste must not get into the slot of the probe body |
5 - | Exhaust gas temperature sender 2 -G448- |
q | 45 Nm |
q | the thread of the new temperature sender must be coated with assembly paste |
q | coat only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender |
6 - | Pressure line - 45 Nm |
7 - | Heat shield |
8 - | 9 Nm |
9 - | Support |
q | for pressure line |
10 - | Diesel particle filter |
q | removing and installing → Chapter |
11 - | Front exhaust pipe |
12 - | Identification |
q | for double clamp |
13 - | Gasket |
q | replace |
q | Check fitting position |
14 - | Clamp - 7 Nm |
15 - | 25 Nm |
16 - | Exhaust gas temperature sender 3 -G527- |
q | 45 Nm |
q | the thread of the new temperature sender must be coated with assembly paste |
q | coat only the thread with hot bolt paste -G 052 112 A3- for re-used temperature sender |
17 - | Support |
q | screwed onto the cylinder block |
18 - | 25 Nm |
19 - | 8 Nm |