skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Test signal from fuel gauge sender G > < Removing and installing the dash panel insert

Octavia Mk1

Contact assignment of plug connections on the dash panel insert
Contact assignment of plug connections on the dash panel insert
   
Multi-pin plug connection for basic functions, 32-pin, blue -T32a-
1 - Terminal 15
2 - Right turn signal light
3 - Speedometer, output 1
4 - Trailer turn signal lights
5 - Fuel tank sender
6 - Light failure
7 - Terminal 31 (sensor mass)
8 - Coolant temperature
9 - Terminal 31 (load mass)
10 - Oil pressure switch
11 - Front right door contact switch (as of MY 02 not assigned)
12 - Terminal 61
13 - Low beam
14 - Rear fog lights
15 - Front fog lights
16 - Tailgate (as of MY02 not assigned)
17 - Main beam
18 - Left turn signal light
19 - Brake light failure
20 - Terminal 58b
21 - Door contact switch driver side (vehicles with central locking) all door contact switches (vehicles without central locking)
22 - Low coolant level
23 - Terminal 30
24 - Terminal 31
25 - K cable
26 - Parking light on the right, side light
27 - Parking light on the left, side light
28 - Speedometer, input
29 - Brake fluid level
30 - S contact
31 - Seat belt lock
32 - Rear left and right door contact switch (as of MY02 not assigned)
  A90-0048
Multi-pin plug connection for extended functions, 32-pin, green -T32b-
1 - not assigned
2 - Transponder coil
3 - not assigned
4 - not assigned
5 - W-line
6 - Washer fluid sensor
7 - Brake pads
8 - not assigned (as of MY02 CAN High)
9 - not assigned (as of MY02 CAN Low)
10 - not assigned
11 - not assigned
12 - Air conditioning system (deactivation) for engine identification characters AEH, AKL
13 - Handbrake
14 - not assigned
15 - not assigned
16 - not assigned
17 - Transponder coil
18 - Oil sensor
19 - CAN drive High
20 - CAN drive Low
21 - Gas discharge lamp failure or step motor failure
22 - Contact switch for the engine hood
23 - MFD - top function selection
24 - MFD - bottom function selection
25 - MFD - Reset/level 1/2
26 - MFD - Outside temperature
27 - CAN drive High - output for diagnostic plug connection
28 - CAN drive Low - output for diagnostic plug connection
29 - CAN drive screening - output for diagnostic plug connection
30 - Clock (only dash panel insert with large dot display)
31 - Data (only dash panel insert with large dot display)
32 - Input data of the navigation
  A90-0049

Test signal from fuel gauge sender G > < Removing and installing the dash panel insert