smart Workshop Repair Guides

Smart Workshop Service and Repair Manuals

Air Bag Systems > < AR83.30-P-5535MCC Remove/install intake manifold filling valve|Page 2426
Page 1
background image

Repairs and Inspections Required After a Collision: Service and Repair

AH54.10-P-0001-01A Notes On Battery

General information on batteries

^

Do not store batteries over a longer period at a storage point with direct solar radiation.

^

Discharged or defective batteries can freeze, therefore store free from frost.

^

Avoid polarity reversal and short-circuits.

^

Do not place tool or other conducting objects on the battery (risk of short-circuit).

^

Before removal and installation of batteries all switchable current consumers should be switched off, as well as the engine switched off so that
inadvertent arcing is ruled out.

^

Always disconnect the negative terminal first and always connect the positive terminal first . 

^

Only charge batteries with DC, 10 % of the capacity is recommended as charging current for slow charging and 50 % of the capacity
recommended for fast charging.

^

Only switch on the charger after connecting to the terminals and switch off before disconnecting.

^

We recommend greasing the batteries slightly with battery terminal grease.

^

If the battery is to remain in the parked vehicle for a longer time, the negative terminal should be disconnected.

^

If possible batteries should be kept clean and dry.

^

Batteries should not be stored over a longer period without recharging.

Notes on lead-gel batteries (additional battery for special bodies)

^

Lead-gel batteries are free from gassing, acid does not run out of them and are completely independent of position and maintenance free.

^

When fast charging ensure that the housing of the lead-gel battery does not heat up excessively otherwise a pressure relief valve will be opened
and the lead-gel battery will be defective. 

Notes on lead acid batteries

^

Always store lead lead-acid batteries horizontally to prevent acid leaking out and do not tilt during transportation.

^

When fast charging ensure that the housing of the lead-acid battery does not heat up excessively.

Air Bag Systems > < AR83.30-P-5535MCC Remove/install intake manifold filling valve|Page 2426