B9 Tribeca F6-3.0L DOHC (2006)
17. Assemble the armature to yoke.
NOTE:
-
Be careful not to allow armature plate to move. It is recommendable to support with cylindrical pipe as shown in the figure.
-
Align the positions of cutout portion of yoke with the rubber part of end frame.
-
Be careful not to damage the magnet.
18. Assemble the yoke to front bracket.
NOTE:
-
Apply grease to the end surface of yoke (mating surface with front bracket).
-
Align the drive out position of yoke outer perimeter with the cutout portion of front bracket.
19. Tighten the through bolts on both sides.