Baja F4-2.5L SOHC (2003)
1. Temporarily install front ABS sensor on housing.
CAUTION: Be careful not to strike ABS sensor's pole piece and tone wheel's teeth against adjacent metal parts during installation.
2. Install front ABS sensor on strut and wheel apron bracket.
Tightening torque: 32 Nm (3.3 kgf-cm, 24 ft. lbs.)
3. Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire
perimeter, tighten ABS sensor on housing to specified torque.
ABS sensor standard clearance: 0.3 - 0.8 mm (0.012 - 0.031 inch)
Tightening torque: 32Nm (3.3 kgf-cm, 24 ft. lbs.)
CAUTION: Check the marks on the harness to make sure that no distortion exists.
NOTE: If the clearance is outside specifications, adjust the gap using spacer (Part No. 26755AA000).
4. After confirmation of the ABS sensor clearance, connect connector to ABS sensor.
5. Connect connector to battery ground cable.
INSPECTION
ABS SENSOR
1. Check pole piece of ABS sensor for foreign particles or damage. If necessary, clean pole piece or replace ABS sensor.
