Baja F4-2.5L SOHC (2003)
2. Install ABSCM&H/U ground terminal to bracket
Tightening torque: 32 Nm (3.3 kgf-cm, 24 ft. lbs.)
3. Connect brake pipes to their correct ABSCM&H/ U connections
Tightening torque: 15 Nm (1.5 kgf-cm, 10.8 ft. lbs.)
4. Using cable clip, secure ABSCM&H/U harness to bracket.
5. Connect connector to ABSCM&H/U.
CAUTION:
^
Be sure to remove all foreign matter from inside the connector before connecting.
^
Ensure that the ABSCM&H/U connector is securely locked.
6. Install air intake duct.
7. Connect ground cable to battery.
8. Bleed air from the brake system.
INSPECTION
1. Check connected and fixed condition of connector.
2. Check specifications of the mark with ABSCM&H/U.
CHECKING THE HYDRAULIC UNIT ABS OPERATION BY PRESSURE GAUGE
1. Lift-up vehicle and remove wheels.
2. Disconnect the air bleeder screws from the FL and FR caliper bodies.
3. Connect two pressure gauges to the FL and FR caliper bodies.
CAUTION:
^
Pressure gauges used exclusively for brake fluid must be used.
^
Do not employ pressure gauge previously used for transmission since the piston seal is expanded which may lead to malfunction of the brake.