Baja F4-2.5L SOHC (2003)
Fuel Gauge Sender: Service and Repair
Fuel Level Sensor
REMOVAL
WARNING:
-
Place "NO FIRE" signs near the working area.
-
Be careful not to spill fuel on the floor.
-
During work procedures, if fuel tank is more than 3/4 full, be careful because fuel may spill.
NOTE: Fuel level sensor is built in fuel pump assembly.
1. Remove fuel pump assembly.
2. Disconnect connector from fuel pump bracket.
3. Pushing the pawls with a screwdriver, remove fuel level sensor by pulling it downwards.
NOTE: If the retainer pawls are broken during removal, the fuel level sensor must be replaced with a new one.
INSTALLATION
Install in the reverse order of removal.
WARNING:
-
Ground cable must be connected.
-
Spark may occur and ignite if fuel is nearby.