Baja F4-2.5L SOHC (2003)
3. Apply proper amount of liquid gasket to the entire oil pan mating surface.
Fluid packing: THREE BOND 1217B (Part No. K0877YA020)
4. Apply liquid gasket fully to three holes other than screw holes on transmission case.
Fluid packing: THREE BOND 1217B (Part No. K0877YA020)
5. Install the oil pan.
Tightening torque: 5 Nm (0.5 kgf-m, 3.6 ft. lbs.)
6. Install the front and rear vehicle speed sensor, and also the torque converter turbine speed sensor, and then fasten the harness.
Tightening torque: 7 Nm (0.7 kgf-m, 5.1 ft. lbs.)
7. Install a new aluminum washer and oil cooler pipes.
Tightening torque:
T1: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
T2: 44 Nm (4.5 kgf-m, 32.5 ft. lbs.)
8. Install the transmission rear crossmember bolts.
Tightening torque: 75 Nm (7.6 kgf-m, 55 ft. lbs.)
9. Install the propeller shaft.
10. Install the shield cover.
11. Install the front, center, rear exhaust pipes and muffler.
12. Lower the vehicle.
13. Install the transmission connector to the stay.
14. Install the pitching stopper.
15. Install the air cleaner case. (2.5 L model)
16. Install air intake chamber. (3.0 L model)
17. Fill ATF and check ATF level.