Baja F4-2.5L SOHC (2003)
4. Apply an even coat of specified grease [20 to 30 g (0.71 to 1.06 oz)] to the entire inner surface of boot. Also apply grease to shaft.
NOTE: The inside of the larger end of BJ boot and the boot groove shall be cleaned so as to be free from grease and other substances.
5. Install boot projecting portion to BJ groove.
6. Set large boot band in place.
7. Install boot projecting portion to shaft groove.
8. Tighten boot bands using ST, torque wrench and socket flex handle.
ST 28099AC000 BOOT BAND PLIER
Tightening torque:
Large boot band 157 Nm (16.0 kgf-m, 116 ft. lbs.) or more
Small boot band 133 Nm (13.6 kgf-m, 98 ft. lbs.) or more
9. Place SFJ boot at the center of shaft.