Forester F4-2.5L SOHC (2004)
4) While holding the hexagonal part of brake hose fitting with a wrench, tighten the flare nut to the specified torque.
Tightening torque (Brake pipe flare nut): 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
5) Bleed air from the brake system.
REAR BRAKE HOSE(DRUM BRAKE)
1) Install the brake hose to wheel cylinder.
Tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
2) Secure the brake hose to bracket on strut using a clamp.
3) Connect the brake hose through hole in bracket on body.
Tightening torque: 15 Nm (1.5 kgf-m, 10.8 ft. lbs.)
4) Bleed air from the brake system.
INSPECTION
Ensure there are no cracks, breakage, or damage on the hoses. Check the joints for fluid leakage. If any cracks, breakage, damage or leakage is found,
repair or replace the hose.