Forester F4-2.5L SOHC (2004)
NOTE:
^
Be careful not to damage the oil seal and bushing inside the torque converter clutch case by the oil pump cover.
^
Be careful not to lose the rubber seal.
11. Remove the seal pipe if it is attached. (Reusing is not allowed.)
12. Remove the differential assembly.
13. Remove the oil seal from torque converter clutch case.
INSTALLATION
1. Check the appearance of each component and clean.
2. Force-fit the oil seal to the torque converter clutch case with ST.
ST 398437700 DRIFT
3. Install the differential assembly to the case.
4. Install the left and right side retainers.
5. Install the new seal pipe to the torque converter clutch case.