Forester F4-2.5L SOHC (2004)
Transmission Speed Sensor: Service and Repair
Front Vehicle Speed Sensor
The content of this article/image reflects the changes Identified in
TSB # 18-100-06
as of 02/06/2006
and applies to 2003 Forester & Impreza Models
Front Vehicle Speed Sensor
REMOVAL
1. Set the vehicle on a lift.
2. Disconnect the ground cable from battery.
3. Remove the air cleaner case.
4. Disconnect the transmission connector.
5. Remove the pitching stopper.
6. Remove the transmission connector from stay.
7. Lift-up the vehicle.
8. Clean the transmission exterior.
9. Drain the ATF completely.
NOTE:
^
Tighten the ATF drain plug after draining the ATF.
^
Replace the gasket with a new one.
Tightening torque: 25 Nm (2.5 kgf-m, 18.1 ft. lbs.)
10. Remove the front, center, exhaust pipes and muffler.