Forester AWD F4-2.5L DOHC (1998)
3) Install rear drive shaft to rear housing and rear differential spindle.
4) Install rear sensor harness on rear trailing link.
Tightening torque:
32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
5) Place a thickness gauge between ABS sensor's pole piece and tone wheel's tooth face. After standard clearance is obtained over the entire
perimeter, tighten ABS sensor on back plate to specified torque.
ABS sensor standard clearance:
0.7 - 1.2 mm (0.028 - 0.047inch)
Tightening torque:
32 ± 10 Nm (3.3 ± 1.0 kg-m, 24 ± 7 ft. lbs.)
CAUTION:
^
Check the marks on the harness to make sure that no distortion exists. (RH: white, LH: yellow)
NOTE:
-
If the clearance is outside specifications, readjust.