Forester AWD F4-2.5L DOHC (1998)
3. Temporarily connect pipes C and D to pipes (on the gearbox side).
4. Temporarily install clamp E on pipes C and D.
CAUTION: Ensure that the "8" letter side of clamp E is on the pipe C side.
5. Tighten joint nut.
Tightening torque: 15 ± 5 Nm (1.5 ± 0.5 kg-m, 10.8 ± 3.6 ft. lbs.)
6. Tighten clamp E firmly.
Tightening torque: 5.4 ± 1.5 Nm (0.55 ± 0.15 kg-m, 4.0 ± 1.1 ft. lbs.)
7. Connect pipes A and B to four pipe joints of gearbox. Connect upper pipe B first, and lower pipe A second.
Tightening torque: 13 ± 3 Nm (1.3 ± 0.3 kg-m, 9.4 ± 2.2 ft. lbs.)
8. Install jack-up plate.
9. Connect battery minus terminal.
10. Feed the specified fluid and discharge air.
CAUTION: Never start the engine before feeding the fluid; otherwise vane pump might be seized up.